|
Herco Fish Pond Thinner-Cleaner - Gallon
$91.00
Thinner-Cleaner is used to mix in to the black coating to thin it sufficiently for easier painting of the pond surface. Uses thinner-Cleaner to clean off pond surface in preparation for the primer coating. After cleaning, the primer coating is recommended before the final neoprene coating. This material is also used to clean up brushes. Needed for Black Rubbber only.
|
|
|
Herco Fish Pond Thinner-Cleaner - Quart
$31.95
|
|
|
|
Herco Fish Pond Crack Filler - Caulk
$35.95
The pond coating compatible crack filler has the same quality found in the other HERCO primer and thinner-coat products. Crack filler comes in a tube that fits into a caulking gun for easy and accurate application. Remains pliable and is applied before being painted with the Herco Pond Coating.
|
|
|
Herco Fish Pond Primer - Gallon
$98.00
Used to prepare the surface to ensure a firm bond. Dries gray. Primer is always recommended prior to applying the pond coating. Soap and water clean-up. Covers 100 to 150 square feet per gallon (depending on surface porousity).
|
|
|
|
Herco Fish Pond Primer - Quart
$36.95
Covers 25 to 37 square feet per gallon.
|
|
|
|
Herco Fish Pond Coating - Black - Gallon
$185.00
One coat of primer and three coats of liquid rubber are recommended for complete sealing of surface. Each gallon of coating covers approximately 100 to 150 square feet for the three coats needed (depends on surface porousity). Black coating must be thinned using the Thinner/Cleaner. Mix in a small amount until desired consistency is achieved. Most people prefer to mix until it is as thin as paint for smoother application.
|
|
|
|
Herco Fish Pond Coating - Black - Quart
$71.95
Each quart of coating covers approximately 25 to 37 square feet for the three coats needed (depends on surface porousity). Black coating must be thinned using the Thinner/Cleaner.
|
|
|
|
Herco Fish Pond Coating - Clear - Gallon
$205.00
One coat of primer and three coats of liquid rubber are recommended for complete sealing of surface. Keep in mind that the primer is gray and the coating will allow the gray to show through. In some cases, the primer is omitted with the idea that the stonework will show through from below the coating. The clear coating dries more of a translucent clear and is not totally clear. A slightly milky finish will result. Water may be added as early as 24 hours after last coat has dried. Each gallon of coating covers approximately 100 to 150 square feet for the three coats needed (depends on surface porousity). Thinner cleaner is not needed for clear coating.
|
|
|
|
HercoFish Pond Coating - Clear - Quart
$76.95
|
|
